iPhone app · Jump power in slow motion
Measure your vertical jump with an iPhone
Powerleap is an iPhone app that measures your jump height from slow-motion video at up to 240 frames per second. Body tracking finds take-off and landing, and the height comes from flight time – with a landing correction and a rise-time check.
Unlimited free measurements · every exercise · no subscription · no ads · no account


What our check shows
Checked on 24 ground jumps by three athletes, filmed at 240 frames per second: 9 indoors with the camera raised, on the floor and low, 9 outdoors with the camera low at about 0.7 m (28 Oct 2026), 6 in a gym with the camera at hip height, 3 of them from about 4 m and 3 from 2.5 m away (30 Oct 2026). Take-off and landing were marked by hand, frame by frame, in every video and compared with the automatic detection of version 1.0.1.
22 of 24
Take-off within ±1 frame
That is how often the automatic take-off mark was at most 1 frame from the hand-set one – in 15 jumps from a range of 2 frames, because the hand-set mark there tends to be 1 frame late. The other two came 2 frames early, both filmed from 4.2 m. Against the hand-set mark alone: 16 of 24. At 240 fps a frame lasts 4.2 ms.
20 of 24
Landing within ±1 frame
Twice the landing mark was 2 frames off, twice 4 frames late (both from about 4 m, heel still high at touchdown). Thanks to the landing correction it barely affects the height.
22 of 24
Height within ±1.5 cm
That is how close the app’s height was to the same calculation with the hand-set marks, against both take-off frames where a range applies. The other two, from 4.2 m, were 2.5 and 2.6 cm too high; from 2.5 m all three were within ±1.5 cm. Against the hand-set mark alone: 16 of 24, at most 3.9 cm off. Every measurement shows its own ±, here 1.2–1.9 cm.
This compares the app with a manual evaluation of the same video, not with a force plate – that comparison is still pending. Recommended setup: hip height, about 2.5 m away. In our check (3 vs. 3 jumps by one athlete) the two outliers in take-off and height were both filmed from 4.2 m; whether that is down to the distance or to the jumping technique has not been separated yet. If the app sees a foot hidden before take-off, as in all three jumps from about 4 m, it asks you to review the jump. All 24 jumps in a table
What you can measure
| Exercise | How the app measures | Result |
|---|---|---|
| Vertical jump (countermovement jump) | Slow motion up to 240 fps, hands-free: set down, beep, jump | Height with ±, take-off velocity, power in watts (with your body weight) |
| Box jump | detects the box itself and measures up to the highest point (rise time) | Height with ± |
| Drop jump | slow motion: touchdown after the drop, take-off, landing | RSI, ground contact time, drop height – more on RSI |
| Repeated jumps | 5–10 quick jumps in a row | RSI of the series, ground contact and RSI for every jump |
| Sprint | camera timing gate with one iPhone at the side: flying, acceleration or with a start signal | Time and speed |
| Top speed | GPS, outdoors | Top speed |
| Standing long jump | 3D camera | Distance (estimate) |
| Readiness | 3 jumps before training, compared with your baseline | fresh, a bit tired or “fatigued – go easy today” – how it is calculated |
Anything that can’t be checked frame by frame – 3D camera, motion sensor, slow motion below 100 frames per second – is labeled “estimate” everywhere in the app and never counts as a record. Powerleap is a training tool, not a medical device.
Pricing
Measuring is free and unlimited. Every exercise, history and CSV export – no subscription, no ads and no account.
Your data stays on your iPhone
Powerleap has no account, no server, no tracking and no ads: videos, measurements and profile values stay on your iPhone and only leave it when you share something yourself. Privacy policy
Learn more
Measure your vertical jump with an iPhone
Setup, formulas, landing correction, error sources and all 24 check jumps.
Vertical jump chart and calculator
Percentiles by age and sex, flight time ↔ height, standing reach.
Measuring methods compared
App, sensor, contact mat and force plate, with sources.
Drop jump and RSI
Definition, formula and how the app measures ground contact time.
Readiness check
Best 2 of 3 jumps against your 14-day baseline.
Contrast training
PAP, PAPE, rest interval from meta-analyses and the contrast check.
Frequently asked questions
How does Powerleap measure jump height?
Your iPhone films you from the side in slow motion at up to 240 frames per second. Apple’s body tracking finds your hips, knees and feet in the frames, and the app derives take-off and landing from them. Jump height is how far your center of mass rises from take-off to the highest point: it comes from flight time with a landing correction, and the rise time serves as a check. How-to and formulas
How accurate is the app?
In 24 checked ground jumps by three athletes (240 fps; camera raised, on the floor, low and at hip height), the automatic take-off mark was at most one frame from the hand-set mark in 22 of 24, the landing mark in 20 of 24, and the height was within ±1.5 cm of the calculation with the hand-set marks in 22 of 24. In 15 jumps the hand-set take-off mark tends to be 1 frame late, so a range of 2 frames counts there, and for the height the range of both calculations. The two jumps where take-off and height fell outside were filmed from 4.2 m: take-off 2 frames early, height 2.5 and 2.6 cm too high; from 2.5 m all three were within ±1.5 cm. Whether that is due to the distance or to the jumping technique, 3 vs. 3 jumps by one athlete cannot tell yet. Against the hand-set mark alone, take-off and height are within these limits in 16 of 24; in the other 8 the take-off came 2–3 frames early and the height 1.9–3.9 cm too high. Every measurement shows its own ± (there 1.2–1.9 cm). Accuracy depends on setup, distance, light and frame rate. A comparison with a force plate is still pending.
Do I need a tripod or a helper?
No. Lean your iPhone upright against a bottle, books or a bag, roughly at hip height and about 2.5 m to the side. After the beep you jump, the app announces your height, and the series keeps going hands-free.
Which devices do I need? Is there an Android version?
An iPhone with iOS 26. Powerleap is available for iPhone only. If the camera delivers fewer than 240 frames per second, the ± grows; below 100 frames per second the value is labeled “estimate” and never counts as a record.
How much does Powerleap cost?
Measuring costs nothing – unlimited, in every exercise, with history and CSV export. No subscription, no ads, no account.
What happens to my videos and measurements?
They stay on your iPhone. The app has no account, no server, no tracking and no ads, and sends nothing to the internet. Data only leaves the device when you share or save something yourself. Privacy policy
How is this different from a jump mat or a force plate?
A contact mat only measures flight time; if you touch down with bent knees (center of mass lower than at take-off), it shows too much. A force plate calculates height from take-off velocity and is the reference in studies. Powerleap measures flight time in the video, corrects for bent-knee touchdowns and lets you review every jump frame by frame. Comparison with sources
Can I also measure box jumps, drop jumps and sprints?
Yes. If you land on a box, the app notices and measures up to the highest point using rise time. The drop jump gives ground contact time and Reactive Strength Index (RSI), repeated jumps give the RSI of every jump. Sprints are timed with one iPhone as a camera timing gate (flying, acceleration or with a start signal), or top speed via GPS.
Can I check whether my heavy set increases my jump height?
Yes, with the contrast check (from version 1.0.1, under “More”): 3 jumps, then your heavy set, and 3 more jumps after 4–8 minutes. The app compares the mean of your best 2 of 3 before and after in cm and %, and from +5% it says “The set helps you today”. Jumps after the set count as records, but not for readiness. Contrast training and the check